RUMCars Forum
General Category => Unusual Microcar Discussion => Topic started by: eaurouge on August 09, 2015, 12:09:39 PM
-
Help...
I have changed the master cylinder.. .Great came off a Fiat 500.... Now the slave/wheel cylinders... I have Fiat 500 ones which are wrong as the shape does not fit the back plate. (Nor do they have the male ends!).
Attached is a picture of my wheel cylinder... any ideas anyone?
Thanks... really want to be able to stop as well as go!
-
Have you tried your local motor factors?
I recall buying brake pads for our beetle when we had it and they were wrong. Went in and looked through the books as they have drawings at the back.
-
That's the plan for tomorrow to go see....
-
Hello
did you have any luck at the motor factors ?
I will try and have a look at mine tomorrow but I am sure they are both (I have a van and a saloon) Fiat 500/126 so 2 different sorts must of been fitted
if it comes to it you could have the old ones sleeved but its not cheap
Peter